However it s not so unusual if you press very hard along edges of a carpet to feel the spikes but they shouldn t be sticking right through if that s what.
Carpet tacks sticking up.
Run a fan or two to dry the carpet.
When i did a carpet installation course we were always told not to install tack strips in walk way areas due to the problems arising such as nails sticking out after the carpet starts to wear.
Of carpet and cut it into easy to handle strips photo 1.
You have to get rid of it asap.
Press down on the carpet firmly without using a hammer so the tacks don t break or bend before they get hold of the carpet.
Fold back about 3 ft.
Continue pulling the carpet off the tack strip by hand until you can fold back the entire wet section.
Get 5 off when you sign up for emails with savings and tips.
Long carpet tack strip for wood or concrete subfloors 3 pack model hd 161 p 8 2 78 package 2 78 package schedule delivery.
Please enter in your email address in the following format.
Just grab the carpet with pliers and pull.
There are really sharp carpet tacks sticking up all along the edges.
Start with a clean area.
When we have to repair these areas we were taught to remove the strip and to directly stick the carpet down using carpet glue a lot safer and lasts longer.
Then grab the carpet by hand and continue to pull it up along an entire wall.
That s the gripper rods spikes that means either carpet is to thin wrong gripper rods used or glue should have been used.
To detach the carpet from the tack strip that holds the carpet in place along walls start in a corner.
Wide x 4 ft.
Wet carpet pad is like a big sponge.
Once the tacks hold the carpet bend the tips so that the tacks won t stick into your feet as you walk.
Tear out the soggy pad first go to the corner nearest the wet area grab the carpet with pliers and pull the carpet off the tack strip.
The tacks will grip the backing and hold the carpet in place.